Life is like riding a bicycle.  To keep your balance you must keep moving.”
Albert Einstein

Sunday, September 23, 2012

AP Physics B Electrostatics – Answer to Free Response Practice Question



“There is no democracy in physics. We can't say that some second-rate guy has as much right to an opinion as Fermi.”
– Luis Walter Alvarez

A free response practice question meant for testing your knowledge, understanding and capacity for application of basic principles in electrostatics was given to you in the post dated 21st September 2012. As promised, I give below a model answer. The question also is given below for your convenience.

Two parallel flat metal plates P1 and P2 , each of area 0.16 m2, are arranged horizontally (Fig.) in air with a separation of 1.5×10–2 m. [Separation is shown exaggerated in the figure for convenience].  A constant potential difference of 60 V is established between the plates so that the electric field in the region between the plates is directed vertically downwards as indicated in the figure. Now, answer the following questions:
(a) If the potential of plate P1 is +10 V, what is the potential of plate P2? Justify your answer.
(b) Determine the magnitude of the electric field between the plates.
(c) Determine the capacitance of the parallel plate capacitor formed by the plates.
(d) Calculate the increase in the energy stored in the capacitor (formed by the plates P1 and P2) when additional charges equal to ten electronic charges.are added to it.  
(e) A charged oil droplet of effective weight 3.2×10–14 newton is found to remain stationary in the space between the plates. Determine the charge on the oil droplet.
(a) The electric field is pointed vertically downwards. This means that the upper plate P1 is at higher potential. Since the potential of P1 is given as 10 V and the potential difference between P1 and P2 is given as 60 V, we have
             10 V2 = 60 V where V2 is the potential of plate P2.
This gives V2 = – 50 V
(b) The magnitude (E) of the electric field between the plates is given by
             E = V/d where V is the potential difference and d is the separation between the plates.
Therefore, E = 60/(1.5×10–2) = 4000 NC–1
(c) The capacitance (C) of a parallel plate capacitor with air (or free space) as dielectric is given by
             C = ε0A/d where ε0 is the permittivity of free space (or air, very nearly), A is the area of the plates and d is the separation between the plates.
Therefore, C.= (8.85×10–12×0.16)/(1.5) = 9.44×10–11 F
(d) Ten electronic charges is a very small amount of charge which is equal to 10×1.6×10–19 coulomb. The potential difference between the plates can therefore be assumed to be unchanged. Therefore, the increase in the energy of the capacitor is V(∆q) = 60×1.6×10–18 joule = 9.6×10–17 joule.
(e) Since the charged droplet is stationery, the effective weight of the droplet acting vertically downwards is balanced by the electric force on it. The electric force is therefore acting vertically upwards. This means that the charge on the droplet is negative.
Equating the magnitudes of the electric force qE and the effective weight W, we have
             q×4000 = 3.2×10–14
Therefore q = (3.2×10–14)/4000 = 8×10–18 coulomb.
Since the charge is negative, the correct answer is –8×10–18 coulomb.

[If you were asked to find the number of electrons gained (or lost) by the droplet, you will answer that the droplet has gained 50 electrons since (8×10–18)/(1.6×10–19) = 50].

Friday, September 21, 2012

AP Physics B Electrostatics – A Free Response Practice Question


“This time, like all times, is a very good one if we but know what to do with it”
– Ralph Waldo Emerson

Today I give you a free response practice question meant for testing your knowledge, understanding and capacity for application of basic principles in electrostatics:
Two parallel flat metal plates P1 and P2 , each of area 0.16 m2, are arranged horizontally (Fig.) in air with a separation of 1.5×10–2 m. [Separation is shown exaggerated in the figure for convenience]. A constant potential difference of 60 V is established between the plates so that the electric field in the region between the plates is directed vertically downwards as indicated in the figure. Now, answer the following questions:
(a) If the potential of plate P1 is +10 V, what is the potential of plate P2? Justify your answer.
(b) Determine the magnitude of the electric field between the plates.
(c) Determine the capacitance of the parallel plate capacitor formed by the plates.
(d) Calculate the increase in the energy stored in the capacitor (formed by the plates P1 and P2) when additional charges equal to ten electronic charges.are added to it.  
(e) A charged oil droplet of effective weight 3.2×10–14 newton is found to remain stationary in the space between the plates. Determine the charge on the oil droplet.
The above question carries 15 points. You may take up to 17 minutes for answering it. Try to answer it yourself within the stipulated time. I’ll come back shortly with a model answer for your benefit.

Monday, September 3, 2012

AP Physics B & C Multiple Choice Practice Questions on Electrostatics


“I never did a day's work in my life. It was all fun.”
– Thomas A. Edison

Questions in the section ‘electrostatics’ were discussed on many occasions earlier on this site. You may access them by clicking on the label ‘electrostatics’ below this post. Since the number of posts displayed per page is limited, you will have to use the ‘older posts’ button to access all the posts.
All posts in this section can equally well be accessed by trying a search for ‘electrostatics’ using the search box provided on this page.
Today we will discuss a few more multiple choice practice questions on electrostatics:

(1) Point charges +q and –3q are arranged at points A and B on the x-axis (Fig.). At which point (or points) is the electric field due to this system of charges zero?
(a) At two points on the x axis, one point to the right of the charge –3q  and the other to the left of the charge +q.
(b) Somewhere on the x axis to the left of the charge +q.
(c) Somewhere on the x axis to the right of the charge –3q.
(d) Somewhere on the x axis, in between the two charges.
(e) The electric field cannot be zero anywhere.
The electric field lines due to a positive charge proceed radially outwards (diverge) from the charge where as the electric field lines due to a negative charge proceed radially inwards (converge) to the charge. At points on the x-axis lying in between A and B the fields due to these charges are directed along the positive x-direction. Therefore, the fields add up and the resultant field cannot be zero. But at points on the x-axis to the left of the charge +q, the fields are in opposite directions (along the negative x-direction due to the charge +q and along the positive x-direction due to the charge –3q) so that they can cancel at a point where the magnitudes of the fields due to the charges are the same. So the correct option is (b).
[At points on the x-axis to the right of the charge –3q, the fields are in opposite directions (along the positive x-direction due to the charge +q and along the negative x-direction due to the charge –3q. But the two fields cannot cancel anywhere here since the magnitude of the field due to the charge –3q is greater than that due to  the charge +q (since the charge –3q is nearer as far as points on the right of B are concerned]
(2) A large flat plate is positively charged so that it has uniform surface charge density σ. If the electric field near the central region of the plate at a distance of 1 cm from the plate is 9 NC–1, what will be the electric field at a distance of 3 cm from the plate?
(a) 81 NC–1
(b) 27 NC–1
(c) 9 NC–1
(d) 3 NC–1
(e) 1 NC–1
The electric field due to the surface charge on the plate is normal to the surface of the plate. Since the plate is large, the electric field near the central region of the plate is uniform (with the electric field lines proceeding normal to the flat surface and therefore parallel). This means that the electric field at a point is independent of the distance of the point from the plate so that electric field at 3 cm from the plate is 9 NC–1 itself.

[For AP Physics C aspirants: 
To find the electric field near the surface of the charged plate, we can apply Gauss theorem and accordingly imagine a Gaussian surface shaped as a rectangular parallelepiped of cross section area A (Fig.). The electric field due to the surface charge on the plate is normal to the surface of the plate. Therefore the electric field is directed normal to the end faces of the rectangular parallelepiped so that the total electric flux through the closed suface (rectangular parallelepiped) is 2EA where E is the magnitude of the electric field. (The flux through the side surfaces of the parallelepiped is zero since the electric field is parallel to these surfaces). The total charge enclosed by the closed surface is σA. Therefore, by Gauss theorem we have
             2EA = σA/ε0 where ε0 is the permittivity of free space.
Therefore E = σ/2ε0, which is independent of distance]



(3) Charges +q, –q and –q are placed at the vertices of an equilateral triangle ABC as indicated in the adjoining figure. What is the direction of the net electric field at the central point P?
(a) Along AP
(b) Along PA
(c) Along CP
(d) Along BP
(e) There is no field at P
The direction of the electric fiel at P is the direction of the force acting on a test positive charge placed at P. The charge +q will exert a repulsive force on the test positive charge. This is irected along AP. The charges –q and –q at B and C will exert attractive forces along PB and PC respectively. These two forces being of equal magnitudes, their resultant will be directed along AP. Therefore the resultant electric field due to all the three charges will be along AP [Option (a)]. 


(4) Points 1, 2 and 3 lie on the axis of an electric dipole AB. Point 4 lie on the equatorial line (perpendicular bisector of AB) of the dipole. Out of the following choices which one correctly gives the directions of the electric fields at the points 1, 2, 3 and 4?        










When you place a positive test charge at point (1) the net force on it is repulsive since the charge +q of the dipole is nearer than the charge –q. The direction of the force (and the electric field) is therefore leftwards.
At point (2) the charge +q exerts a repulsive force on the positive test charge where as the charge q exerts an attractive force on it. Thus both forces act rightwards an hence the electric field at point (2) acts rightwards.
At point (3) the net force on the positive test charge is attractive since the charge –q of the dipole is nearer than the charge +q. The electric field at point (3) is therefore leftwards.
At point (4) the positive test charge  is repelled by the charge +q and attracted by the charge –q. these forces are equal in magnitude and are inclined equally upwards and downwards respectively.  Their resultant acts rightwards and hence the electric field at point (4) is rightwards.
The above facts are correctly given in option (e).
If you have a mental picture of the distribution of the electric field lines due to an electric dipole (See the figure below), you will be able to answer the above question in no time].
 


(5) In the above question, in the case of the points (1), (2), (3) and (4), where do you find zero electric potential?
(a) Nowhere
(b) At point (1)
(c) At points (1), (2) and (3)
(d) At points (2) and (4)
(e) At point (2)
Points (2) and (4) are equidistant from the charges +q and –q. These equal and opposite charges produce positive and negative potentials of equal values so that they cancel each other, giving rise to zero potential at points (2) and (4).